1. 数据恢复操作的优先级提到最高级别

• 默认

# ceph daemon mon.k003 config show | grep osd_recovery_op_priority"osd_recovery_op_priority": "3",

• 参数设置为 63

# ceph tell osd.* injectargs --osd_recovery_op_priority 63

# ceph daemon osd.0 config show | grep osd_recovery_op_priority"osd_recovery_op_priority": "63",

2. 回填并发操作数

• 默认

# ceph daemon mon.k003 config show | grep osd_max_backfills"osd_max_backfills": "1",

• 参数设置为 50

# ceph tell osd.* injectargs --osd_max_backfills 50

# ceph daemon osd.0 config show | grep osd_max_backfills"osd_max_backfills": "50",

3. 恢复的并发操作数

• 每个OSD上同时进行的所有PG的恢复操作（active recovery）的最大数量

# ceph daemon mon.k003 config show | grep osd_recovery_max_active"osd_recovery_max_active": "3",

# ceph tell osd.* injectargs --osd_recovery_max_active 50

# ceph daemon osd.0 config show | grep osd_recovery_max_active"osd_recovery_max_active": "50",

4. OSD在某个时刻会为一个PG启动恢复操作数

# ceph daemon osd.0 config show | grep osd_recovery_max_single_start"osd_recovery_max_single_start": "1",

# ceph tell osd.* injectargs --osd_recovery_max_single_start 5

# ceph daemon osd.0 config show | grep osd_recovery_max_single_start"osd_recovery_max_single_start": "5",

参考

1. 控制数据恢复及回填速度
2. Ceph 业务优先和恢复优先配置